Vented Twin Screw Extruder

Dear Sir

Offer OF VEN TED REPROCESSING PLANT MODEL S-100-175-200 Twin screw feeding

A. EXTRUDER:-

1. Frame :-Rigid frame made from channel & Sheet

2. Screw:-100MM Made of Alloy steel EN41 B ,Nitrided ,hardness 65RC ,Mirror

Polished,LD Ratio 32:1.

2a. Twin screw for feeding of material

2b. Barrel :- 100mm Made of Alloy Steel EN41B,Nitrided and hardness 65 RC,Grinding

and honning.

2c. Twin barrel for feeding of material with bearing block

3. Main Motor - 40 hp,1440 RPM AC (Crompton /Kirloskar) with ac drive

4. Gear Box :- Helical gear box 200

5. Output:- 100-125kg/hr ( Depend on material)

6. Cooling Arrangement:- It is provided at the base of the hopper on the barrel of the extruder. Barrel all zone will be cooled by blower

7. Heater mica

8. Vcccum pump:- 3hp with fitting Klosker make

9. Hopper cramer with 5hp motor and gear box

9 B:-PANEL

Make of MS Sheet Switch gear (BCH OR L&T)

1. 9 NO Digital Temperature controller

2. 9NO Contactor make 16AMP

3. 9NO Amp. Meter 0-30amp

4. 1No Volt Meter 0-500V,and 1No Amp. Meter 0-100 A,

5. Phae Indicator and on /of f switch

10 . HYDRAULIC SCREEN CHANGER

1. Materail alloy steel

2. Hydraulic operated

3. 3hp power pack with standard make motor and hydraulic component

4. Screen dia 10”inch

11. Water Tank:= 19”*19”*7’ SS Sheet and frame angle

12 Air Blower with 3hp motor and starter

13 Stand cutter :- 8” with 5hp motor and starter